Welcome to the HeavyMetalPro Forums http://forums.heavymetalpro.com/ |
|
Hellfly HFY-3G http://forums.heavymetalpro.com/viewtopic.php?f=20&t=22169 |
Page 1 of 1 |
Author: | Karagin [ Sun Jun 17, 2018 10:17 am ] |
Post subject: | Hellfly HFY-3G |
Code: BattleMech Technical Readout Type/Model: Hellfly HFY-3G Tech: Inner Sphere / 3132 Config: Biped BattleMech Rules: Level 3, Standard design Mass: 20 tons Chassis: Ford CVX 21 Endo Steel Power Plant: 120 GM Light Fusion Walking Speed: 64.8 km/h Maximum Speed: 97.2 km/h Jump Jets: 6 Chilton 360 Standard Jump Jets Jump Capacity: 180 meters Armor Type: Riese-500 Ferro-Fibrous Armament: 1 NAIS Med X-Pulse Laser 1 Diverse Optics Type II ER Medium Laser Manufacturer: DyCon Industries Location: Kathil Communications System: Datacom 26 Targeting & Tracking System: Federated Stalker ------------------------------------------------------------------------------ ==Overview:== The HFY-3G was the second mass-produced scout and recon 'Mech to be completed by DyCon Industries. a subsidery of Hardsell Conglomrate. First designed after In 3079, the first Hellfyly came off the assembly line in 3080. The Hellfly was designed as a scout and reconnaissance 'Mech, but it was found to be more succesful hunting down other scout 'Mechs during the Jihad. Though lightly armored and mounting limited weapons the Hellfly uses speed and maneuverability, to make it a difficult target and a tough 'Mech to pin down. ==Battle History:== During a raid on Malore by elements of the Seventh Capellan Lancers in 3092, Captain Walter Tannion led a unit of six Hellflys during the Battle of Markerson. Attacking the recon lance of the Lancers, Captain Tannion's lighter 'Mechs harrased the enemy but were soon cornered ands torn to bits by the heavier enemy units. This is after three weeks of constant hit and run attacks that had the Lancers spending more time chasing Tannion's mechs then they did on destroying the production facilites on Malore. -------------------------------------------------------- Type/Model: Hellfly HFY-3G Mass: 20 tons Equipment: Crits Mass Int. Struct.: 33 pts Endo Steel 14 1.00 (Endo Steel Loc: 5 LA, 4 RA, 2 LT, 2 RT, 1 CT) Engine: 120 Light Fusion 10 3.00 Walking MP: 6 Running MP: 9 Jumping MP: 6 Heat Sinks: 11 Single 7 1.00 (Heat Sink Loc: 1 HD, 3 LT, 3 RT) Gyro: 4 2.00 Cockpit, Life Supt., Sensors: 5 3.00 Actuators: L: Sh+UA+LA+H R: Sh+UA+LA+H 16 .00 Armor Factor: 69 pts Ferro-Fibrous 14 4.00 (Armor Crit Loc: 2 LA, 3 RA, 2 LT, 2 RT, 1 CT, 2 LL, 2 RL) Internal Armor Structure Value Head: 3 9 Center Torso: 6 8 Center Torso (Rear): 4 L/R Side Torso: 5 7/7 L/R Side Torso (Rear): 3/3 L/R Arm: 3 6/6 L/R Leg: 4 8/8 Weapons and Equipment Loc Heat Ammo Crits Mass -------------------------------------------------------- 1 Med X-Pulse Laser RA 6 1 2.00 1 ER Medium Laser LA 5 1 1.00 6 Standard Jump Jets: 6 3.00 (Jump Jet Loc: 3 LT, 3 RT) -------------------------------------------------------- TOTALS: 11 78 20.00 Crits & Tons Left: 0 .00 Calculated Factors: Total Cost: 2,257,440 C-Bills Battle Value 2: 575 (old BV = 467) Cost per BV2: 3,925.98 Weapon Value: 190 / 190 (Ratio = .33 / .33) Damage Factors: SRDmg = 10; MRDmg = 3; LRDmg = 0 BattleForce2: MP: 6J, Armor/Structure: 2/1 Damage PB/M/L: 1/1/-, Overheat: 1 Class: ML; Point Value: 6 |
Page 1 of 1 | All times are UTC-04:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |