Ok here's the problem: I'm posting my essays, I have a few "charts" for lack of a better word that I made in the MS Word document. They look bad and nothing lines up.
Now I had a similar problem over at the CBT boards and was told to line the doc up in Notepad and then use the pre codes that they have over there. Stuff looks good.
I try that over here and no luck.
Here it is with codes:
Code:
Tentage & Support Equipment Mass per m² Cost per m²
Frame, Pop-up 8kg 50C-Bills
Frame, Assembly Required 7kg 25C-Bills
Airframe, GP-sized 5kg 50C-Bills
Airframe, Large 10kg 100C-Bills
Equipped with built-in Electrical Outlets & Lights .5kg 15C-Bills
Climate-Control Unit*, Heater Only .5kg 15C-Bills
Climate-Control Unit*, Heat Pump .75kg 25C-Bills
Portable Flooring 2kg 2C-Bills
And here it is without:
Tentage & Support Equipment Mass per m² Cost per m²
Frame, Pop-up 8kg 50C-Bills
Frame, Assembly Required 7kg 25C-Bills
Airframe, GP-sized 5kg 50C-Bills
Airframe, Large 10kg 100C-Bills
Equipped with built-in Electrical Outlets & Lights .5kg 15C-Bills
Climate-Control Unit*, Heater Only .5kg 15C-Bills
Climate-Control Unit*, Heat Pump .75kg 25C-Bills
Portable Flooring 2kg 2C-Bills
And that's the closest I can get. Help is appreciated.